Videotec MAXIMUS MHXT User Manual download pdf (Page 33)

Instructions manual - English - EN

7.3.15 Closing the housing

Test system operation for positive results

before closing the caps and allowing the

presence of a dangerous atmosphere.

Be careful not to damage the explosion

proof joint.

Insert the slide into the case by sliding it under the

guides.

Fig. 42

Before closing the rear ange verify the

integrity of the sealing ring. If the sealing

ring is damaged replace it with the one

supplied.

Verify that in the cap there isn’t dirt or debris.

Lubricate the part coupling with the back ange with

technical vaseline oil lubricant.

Arrange the cables so that there is no interference

during the closure.

In the integrated wiper version connect the

wiring before closing the housing. (7.3.12

Enabling the wiper, page31).

Insert the rear ange if the housing body having

aligned holes in between the two parts.

Be very careful not to damage the o-ring

gasket.

Tighten the 8 screws removed before.

Pay attention to the xing. Tightening

torque: 9-12Nm max.

Fig. 43

7.3.16 Earth wiring connection

The housing must be connected to

potential equalization ground through M5

threaded hole on the back ange.

Fig. 44

This is for supplementary bonding connection

required by law. In any case a protection earthing

conductor must be applied to the inside connector

(J9) (7.3.3 Connection of the power supply line, page

21).

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 45 46

No comments

Videotec MAXIMUS MHXT User Manual Page 33