Videotec DCJ User Manual download pdf (Page 152)

Page 20 MNVADCJ01_0543

4.6 Accepting the request for monitors

Accepting the monitors is used to prevent an unauthorised operator from operating monitors that are not within

his duties.

4.6.1 Default sett ing

The default setting allows control of all monitors, erasing any previously defined setting.

4.6.2 Modifying t he list

The procedure for accepting and disabling the monitors is the same as that just described for the cameras (see

§ 4.5 - Accepting requests for cameras and assigning receivers, page 16).

Usually 99 monitors can be selected from the keyboard.

4.7 Accepting the request for multiplexers

Accepting the multiplexers is used to prevent an unauthorised operator from operating multiplexers that are not

within his duties.

4.7.1 Default sett ing

The default setting allows control of all multiplexers, erasing any previously defined setting.

4.7.2 Modifying t he list

The procedure for accepting and disabling the multiplexers is the same as that just described for the cameras

(see § 4.5 - Accepting requests for cameras and assigning receivers, page 16).

Usually 39 multiplexers can be selected from the keyboard.

4.8 Accepting requests for functions

Each operator can be enabled (or not) to carry out specific operations from the keyboard.

These are divided into groups of functions and are:

5,9Q,;7: enabling camera selection with the 9 and 8 keys; since these keys are able to cause a

break in the automatic sequence it may be necessary to disable them if this likelihood is to prevented.

21S725/.P: enabling monitor change; if an operator has a single monitor, this can be frozen so that it

cannot be changed any more.

S+,2,783: enabling video device (switcher or matrix) setup; even if enabled this can be subject to

insertion of a password

,*,S9P,783: enabling dome or telemetry receiver setup; if enabled this can also be subject to a password

U(50,6,7: enabling reset of video device alarms; if enabled this can also be subject to a password

2<67S*T: enabling use of joystick

,16,6 enabling control of lens functions in telemetry receivers

8723(1Q*(1: enabling changes to pan & tilt /dome movement by sending autopan and scan type

commands

,*,S9,5/.: enabling change to receiver number associated with a camera

,U(<6: enabling relays control

S3,5Q(6/,5: enabling wiper and washer control.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 259 260

No comments

Videotec DCJ User Manual Page 152