Videotec HTV32K2A000 Specifications download pdf (Page 6)

EN - English - Instructions manual

4

6 Installing and assembling

h

Only specialised personnel should be

allowed to install and assemble the device.

6.1 Installation

6.1.1 How to open the housing

To open the housing, loosen the 2 screws on

the side, turn the cover and the upper half of

the body about the opening hinge axis.

Fig. 01

In this way there will be easy access

to the inside of the housing.

6.1.2 Camera installation

This section describes how to install the camera

inside the housing. It should be remembered that

the power supply can be taken from the circuit

supplied after making sure it is correct one.

Open the housing as described before.

5 Preparing the

product for use

h

Any change that is not expressly

approved by the manufacturer

will invalidate the guarantee.

5.1 Contents and unpacking

When the product is delivered, make sure that

the package is intact and that there are no

signs that it has been dropped or scratched.

If there are obvious signs of damage,

contact the supplier immediately.

Keep the packaging in case you need

to send the product for repairs.

Check the contents to make sure they correspond

with the list of materials as below:

• Housing

• Housing equipment:

• Allen wrench

• Spacers

• Cable glands (x3)

• Cable glands gaskets

• Screws and washers

• Screws for camera

• Desiccant salt bag

• Instructions manual

5.2 Safely disposing of

packaging material

The packaging material can all be recycled.

The installer technician will be responsible for

separating the material for disposal, and in

any case for compliance with the legislation

in force where the device is to be used.

Bear in mind that if the material has to be returned

due to a fault, using the original packaging

for its transport is strongly recommended.

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Comments to this Manuals

No comments