Videotec HGV52K1A100 Specifications download pdf (Page 9)

EN - English - Instructions manual

Position the blade in the stop position.

Fig. 16

The correct adjustment must allow the

return of the blade to the stop position

going to the end stop on the casing’s plate.

Fasten the whole assembly by means

of the washer and nut.

Fig. 17

6.2.5 Fastening of the small

plate with nozzle

Fasten the plate with nozzle already assembled to the

lower casing by means of the two screws supplied

Fig. 18

To calibrate the jet direct the nozzle

towards the glass of the housing.

Fasten the nut to ﬁx the nozzle in its position.

6.2.6 Closing the housing

Close the housing following the opposite

procedure ("6.2.1 Opening of the housing", page

5). Fasten with tightening torque of 1,6Nm.

Replace the standard plate by undoing

the 4 fastening screws.

Fig. 13

Position the EPDM gaskets between

the new plate and the housing before

fastening it to the housing itself.

Fig. 14

6.2.4 Fastening of the wiper blade

Insert the blade in the wiper shaft.

Fig. 15

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

No comments

Videotec HGV52K1A100 Specifications Page 9