Videotec HEK30D0Y000B Specifications download pdf (Page 11)

EN - English - Instructions manual

How to install the 6.1.5

camera power supply

This chapter describes how to install the camera

power supply option into the housing.

The camera power supply has an input voltage

of 100-240Vac and an output voltage of

12Vdc, 1A or an input voltage of 115/230Vac

and an output voltage of 24Vac, 400mA.

IN 100-240Vac - OUT 12VdcFig. 12

IN 115/230Vac - OUT 24VacFig. 13

Remove the body as described in

paragraph How to open the housing.

Slide oﬀ the back of the housing. Replace the

standard electronic card with the kit (01) card

using the 2 ﬁxing screws (02). Carry out the

connections on the new electronic board.

Insert the power supply (03) on the support bracket

(04). Fix the power supply and the bracket onto the

back of the housing using the screws supplied (05).

Fit the six-pole connector at the end of the

cable into its corresponding cable, marked

J2 on the support circuit (Fig. 09).

Fig. 14

Close the housing and reﬁt the screws.

12Vdc power supply6.1.4.1

Remove the body as described in

paragraph How to open the housing.

Fix the blower kit on the rear cover (01) using the

supplied screws (02) with the air ﬂow towards

the interior. We wish to remind that normally the

rear cover, provided for blower kit, are supplied

with a ﬁlter for the air intake which replaces

one of the 3 equipped M16 cable glands.

Fig. 11

Carry out the connections to a corresponding

source of power (if available, it will be possible

to draw it from the heating circuit terminals

responsible for supplying power to the camera).

Close the housing.

24Vac power supply:6.1.4.2

Remove the body as described in

paragraph How to open the housing.

Carry out the connections between the

blower kit and the relevant circuit (Fig. 09).

Fix the blower kit on the rear cover (Fig. 11, 01)

using the supplied screws (Fig. 11, 02) with the air

ﬂow towards the interior. We wish to remind that

normally the rear cover, provided for blower kit,

are supplied with a ﬁlter for the air intake which

replaces one of the 3 equipped M16 cable glands.

Fix the printed circuit on the slide’s pre-arranged

studs near the rear cover plate (Fig. 01, 03). Carry

out the connections of the circuit to the external

source of power 24Vac. The above circuit can also

control the PTC thanks to the thermostat assembled.

The dustproof housings are pre-arranged

for ﬁxing possible ground connections to be

carried out in compliance with the legislation in

force. In the circuit there is also the possibility

of drawing power supply for a camera.

Close the housing.

If heating has been already arranged,

replace the current circuit with the new one.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Comments to this Manuals

No comments

Videotec HEK30D0Y000B Specifications Page 11

Comments to this Manuals

Related products and manuals for Camera housings Videotec HEK30D0Y000B